Archive for April, 2010
Just up on Veer, this all-inclusive collection of my fonts is on sale at 30% off the total of what they would cost if purchased individually. Veer’s special promotion will be ongoing until the middle of May.
SignQuest was the company that RoadStoves had recommended to “wrap” the truck with the graphics I had designed. They produce large scale banners and signs as well as vehicle wraps. One interesting project they were recently involved with was wrapping the Hollywood Sign for the “Save the Peak” campaign. The goal of this campaign is to raise funds to purchase the land adjacent to the Hollywood sign. Hopefully this would prevent commercial development that would permanently mar the view of the iconic sign and the world-famous silhouette of the hills that frame it. Wrapping the Hollywood Sign was a complex project, but wrapping a truck properly is also difficult and time consuming.
Getting it right means placing the many strips of 3M Controltac vinyl film in the right positions:
Louie Navarro is seen above carefully positioning the vinyl on the service side (the side from which the food will be served) of the truck. He must carefully gauge where to position the film at the back of the truck so that the graphics end up at the right spot by the time they reach the front.
Over on the driver’s side, Louie positions the main graphics. There are many ins and outs to the truck surface, and the Controltac film is flexible enough to conform to them all, ending up looking very much as if it had been painted on. It’s pretty amazing.
Here’s one photo of the driver’s side. I’ll post more photos from different angles as they become available.
Photo: Adam Stein
Due to my inability of being able to get good photographs of the completed Canter’s truck, I’m holding up posting the final chapter in this saga. I hope to be able to get some better shots by the end of this week. If not I’ll just post what I’ve got.Thanks for your patience!
Above: Careful placement of my credit below the trash receptacle.